Amana Ptac Wall Sleeve Installation Instructions

This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to.

Amana ptac wall sleeve installation instructions.

Refer to the installation instructions supplied with the ptac wall sleeve for a complete description of the installation procedure. Slide the wall sleeve into the wall opening. Warning ge sleevewall holes amana trane slotted holes wall sleeve holes various attachment hole locations gree carrier and bryant wall sleeve holes a08516 fig. Page 3 pre installation considerations before proceeding with the sleeve installation ensure the following guidelines for locating the wall opening and sleeve are met.

Slide the wall sleeve into the wall opening. Do not distort the cabinet shape to fit the wall opening. With the installation instructions before it is used. Sleeves may be shipped separately to allow for installation during construction.

Heating cooling ptac the amana ptac systems are manufactured under license by goodman global inc. Do not distort the cabinet shape to fit the wall opening. When a drain kit is to be installed do so before top of wall sleeve installing the wall sleeve in the wall. When you visit any website it may store or retrieve information on your browser mostly in the form of cookies.

The amana hvac systems are manufactured under license by goodman global inc. Wall sleeve installation after the wall opening is checked and approved for strength location size and clearances install the wall sleeve as follows. A slight downward pitch from the indoor side to the outdoor side as shown below. Remove the outside enclosure panel from the wall sleeve.

The extra deep sleeves can be custom ordered starting at 16 to 24 in 1 increments as well as from 28 to 36. 6 ptac unit to wall sleeve mounting screws a07057 fig. Sleeve to drain some of the water into the sleeve. The ws900e is an industry standard depth of 14.